Are you considering installing a black stone shower floor but don’t know where to start? Look no further! In this informative guide, we will walk you through the process of installing a stunning black stone shower floor in your bathroom. Follow these steps to create a beautiful and elegant shower space that will impress everyone who enters.
Step 1: Gather the Required Materials
The first step in any successful project is to gather all the necessary materials. To install a black stone shower floor, you will need the following:
- Black stone tiles
- Thinset mortar
- Grout
- Grout sealer
- Trowel
- Tile spacers
- Level
- Grout float
- Sponge
- Bucket
- Measuring tape
- Tile cutter or wet saw
Make sure you have all the materials on hand before you begin the installation process.
Step 2: Prepare the Shower Floor
Start by preparing the shower floor for tiling. Remove the existing flooring, ensuring a clean and even surface. Next, check the floor’s slope to ensure proper drainage. If needed, add a slope to the floor to guide water towards the drain.
Once the floor is prepped, it’s time to apply the thinset mortar. Mix the thinset according to the manufacturer’s instructions, ensuring a smooth and consistent texture. Using a trowel, apply a layer of thinset to the shower floor, working in small sections at a time. Make sure to spread the mortar evenly, creating a flat and even surface for the black stone tiles.
Step 3: Install the Black Stone Tiles
Once the thinset is applied, it’s time to install the black stone tiles. Start by applying a small amount of thinset to the back of each tile and press it firmly onto the mortar, using the tile spacers to maintain consistent spacing between tiles. Continue this process until the entire shower floor is covered with the black stone tiles.
If you need to cut any tiles to fit around edges or fixtures, measure and mark the tiles before using a tile cutter or wet saw to make the necessary cuts. Take your time and ensure each tile fits perfectly into place.
Step 4: Grouting and Finishing
Once the black stone tiles are installed, allow the thinset to dry completely, following the manufacturer’s recommended drying time. After the thinset is dry, it’s time to grout. Apply the grout to the spaces between the tiles using a grout float, making sure to fill all the gaps.
After applying the grout, wipe away any excess using a damp sponge, moving diagonally across the tiles. Allow the grout to dry for a specified time, typically 24 to 48 hours, before applying a grout sealer. The sealer will help protect the grout from stains and make it easier to clean in the long run.
And voila! You’ve successfully installed a black stone shower floor. Admire your handiwork and enjoy the beauty of your new shower space!